Publicité
Les langues disponibles
Les langues disponibles
BEFORE CALLING FOR SERVICE
Problem
Drying time is not
• Heat settings, load size, or
consistent
Clothes take too
• Load is not properly sorted.
long to dry
• Large load of heavy fabrics.
• Dryer controls are not set
• Lint filter needs to be
• Exhaust ducts blocked, dirty,
• House fuse is blown, circuit
• Dryer is overloaded.
• Dryer is underloaded.
Clothes are wrinkled
• Clothes dried too long
• Clothes left in dryer too long
Clothes are shrinking
• Garment care instructions
• Ductwork is too long or has
FLOW SENSE
indicator light is on
during the drying
• Significant blockage of the
cycle
(cont.)
Possible Causes
dampness of clothing is not
consistent.
properly.
cleaned.
or duct run is too long.
breaker has tripped, or
power outage has occurred.
(overdried).
after cycle ends.
are not being followed.
too many turns/restrictions.
ductwork due to lint buildup
or debris.
Solutions
• The drying time for a load will vary depending on the
heat setting, the type of heat used (electric, natural,
or LP gas), the size of the load, the type of fabrics,
the wetness of the clothes, and the condition of the
exhaust ducts and lint filter.
• Separate heavy items from lightweight items. Larger
and heavier items take longer to dry.
• Heavy fabrics take longer to dry because they tend
to retain more moisture. To help reduce and maintain
more consistent drying times for large and heavy
fabrics, separate these items into smaller loads of
a consistent size.
• Use the appropriate control settings for the type of
load you are drying.
• Make sure the lint filter is cleaned before every load.
With some loads that produce high amounts of lint, it
may be necessary to clean the filter during the cycle.
• Confirm that the exhaust ductwork is properly
configured and free of debris, lint, and obstructions.
Make sure that outside wall dampers can open
properly and are not blocked, jammed, or damaged.
• Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have
it corrected by a qualified electrician.
• Divide larger loads into smaller loads for drying.
• If you are drying a very small load, add a few extra
items to ensure proper tumbling action.
• Overdrying a load of laundry can lead to wrinkled
clothes. Try a shorter drying time, and remove items
while they still retain a slight amount of moisture.
• Remove items from the dryer immediately at the end of
the cycle. Use the WRINKLE CARE option to continue
tumbling clothes at the end of the cycle, for up to 3 hours.
• To avoid shrinkage, please carefully follow the fabric
care instructions for your garment, because some
fabrics will naturally shrink when washed. Other fabrics
can be washed but will shrink when dried in a dryer. Use
a low or no heat setting and/or the RACK DRY option.
• Install a shorter or straighter duct run. See the
Installation Instructions.
• D uctwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times
may be longer.
35
Publicité
