Garland MULE 541 QG Manuel D'instructions page 47

Empty the engine oil:
- If it sucks the used oil: remove the engine oil plug
(Y1) and vacuum the motor oil by inserting the
Garland vacuum cleaner tube (REF.: 7199000020,
not included with machine) to the bottom.
- If you choose to empty the drain (Y2) through the
drain plug, please note the trajectory that the oil
will take into the chassis, place a large container to
catch all of the oil before it spills on the ground.
- We recommend that you put a big plastic covering
on the area in which you will change the oil so that
oil does not fall on the ground. Once the work area
is prepared, remove the filling cap (Y1) and remove
the (Y2) oil drain plug and slightly tilt the machine
so that the oil comes out and falls into the
container.
- Once all of the oil has been drained, put the drain
plug back in the machine.
8.2.3. CHECKING THE SPARK PLUG
When it comes to starting a machine, the most
common problems are produced by a dirty spark plug
or one in poor condition. Clean and check the spark
plug regularly.
Check that the electrode gap is correct (0.6 - 0.7
mm).
8.2.4.CLEANING THE CYLINDER FINS
The cylinder fins are responsible for the cooling of the
engine due to its contact with the air. These fins must
be clean and without any material including those that
limit the flow of air.
47/160
English