JVC RD-F321W Notice D'utilisation page 60

USB OPERATION
Inser ng and removing a USB memory device
Carefully insert a USB memory device into the USB port. To remove the USB memory
device simply pull it out.
Selec ng USB mode
Set the FUNCTION switch to the CD/MP3/USB/AUX posi on and then press and hold
STOP/USB to select the USB mode.
• The display will show the total number of folders and the total number of tracks.
Playback control in USB mode is similar to CD mode.
NOTE: The USB memory device should not be removed during playback as damage or
corrup on of es may occur.
AUX IN
Connect an audio cable (not supplied) to the AUX IN jack on the rear of the unit.
Connect the other end to a suitable output socket on your auxiliary device.
Set the FUNCTION switch to the CD/MP3/USB/AUX posi on.
You can play music from an auxiliary device through the speakers of the player.
TROUBLESHOOTING
Problem
The player will not
play.
CD skips while
playing.
Radio sound
distorted.
No radio sound.
SPECIFICATIONS
Power Source:
Radio Frequency Range:
Possible Cause
1. Unit not in CD mode.
2. CD is not installed or installed
incorrectly.
Disc is dirty or scratched.
1. The sta on is not tuned in.
2. There is interference.
1. The unit is not in radio mode.
2. The volume is on the
minimum se ng.
AC 230V~ 50Hz 14W or
DC 9V UM-2 X 6 ba eries
FM 87.5 – 108 MHz
Direct Current
GB-11
Possible Solu on
1. Select CD mode.
2. Load a CD with label side
up.
Wipe the disc with a cloth or
use another disc.
1. Fine tune the sta on.
2. Reposi on the unit.
1. Select radio mode.
2. Adjust the volume level.