BEROTEC K TM 690 Manuel D'utilisation page 16

B E R O T E C
T e m p e r a t u r e d e t e c t i o n
The CUMPAN has two separate temperature detections:
1. The ambient temperature
Sensor integrated in the supply line of the device, approx. 40mm from the
»
housing away
Adjustable temperature warner warns of icy conditions
»
2. The engine temperature
Sensor included in scope of delivery
»
Recording of the engine temperature either at the oil/cooling water circuit or
»
engine housing
Adjustable temperature warner warns of overheating
»
NOTE
speeds in this temperature range.
R P M d e t e c t i o n a n d s h i f t f l a s h
The speed is determined and evaluated via the so-called „crankshaft position sen-
sor". In every modern combustion engine, the position of the crankshaft must be per-
manently determined in order to coordinate ignition timing and injection. Therefo-
re, all the necessary data is already available. All that needs to be done is to tap the
signal cable of the installed sensor. The electronics of the vehicle are not affected.
A list with connection examples can be found on our website. This list will be extended
continuously. The one-time adjustment to the correct sensor is done in the menu of the
CUMPAN. This is done by increasing or decreasing the number of „pulses per crankshaft
revolution". There are already preset values stored, which are suitable for most vehicles.
An integrated shift flash can be set under engine temperature control. The CUMPAN effec-
tively warns of damaging speeds when the engine is cold.
16
The engine temperature is not displayed below 10°C for tech-
nical reasons. The engine should not be loaded by too high
CUMPAN
Deutsch