Publicité
Les langues disponibles
Les langues disponibles
ERGON BIKE ERGONOMICS
Adjusting the back length
Recommendation for the adjustment of the back
length (see table on the back page of these
instructions).
To assess the correct fi t of your backpack, your height
and clothing size can be used. All measurements are
suggestions and are based on average body sizes.
Personal fi t and preference may vary.
Adjustment
Loosen the shoulder straps and put the pack on. Fasten the
hip belt. The hip belt is correctly positioned when the top
of the hip belt is follows the line of the pelvis (+/- 3cm) and
relatively tight. It should not be positioned across the stomach
(Fig. 1). Tighten the shoulder straps until there is little or no
slack in the system. They should not press into your shoulders.
Fig. 1
Automatic adjustment of the shoulder strap angles
Thanks to the two D rings at the top of the shoulder straps, the
carrying system has a certain amount of automatic adjustment.
Sit on a bicycle, or on a stool and mimic the position on a
bicycle. The coloured adjustment marks allow the user to
check that the hip belt is the correct size and the back length
is correctly adjusted. This is the case when the coloured
adjustment marks cross. If this is not the case, please re-
adjust the pack (Fig. 2).
Fig. 2
12
EN
Publicité
