Publicité
Multicast function means that a receiver can be connected to many transmitters, (up to 8 transmitters) by
using the remote control.
Connecting multiple transmitters with one receiver
1.
Press the [MENU] key of the remote control to enter the MAIN MENU, press the directional keys to select
[Add new Video Source] or press the [Add] key to add a video source. Please be sure that the remote
control is pointing to the receiver's IR sensor.
2.
"Please Activate Registration On Transmitter Unit" will appear on the screen. Press the STANDBY
BUTTON on the transmitter for 1 second to activate the Registration then a progress bar will appear.
3.
The Registration will be completed within 3 minutes.
4.
The Transmitter will be connected automatically and transmit audio and video after the Registration.
5.
To add more than one video source, please repeat steps 1-3 after connecting each device.
USB Input
•
The USB connection is compatible with a USB keyboard or mouse (only one device at a time).
•
Using a USB hub or external harddrive will not work with this device.
Setting Up a Keyboard or Mouse with the USB Input
1.
Connect a USB cable from your computer to the transmitter's USB connection.
2.
Connect your keyboard OR mouse to the receiver's USB connection.
3.
On your computer, navigate to Display Properties (or screen properties).
4.
Under the Settings tab in Display Properties, choose your HDTV system as either the "Primary Monitor"
or "Monitor 2".
•
Works with both PC and MAC systems.
Standby Function
1.
On the receiver, press and hold the Standby key for 3 seconds and the receiver will go into Standby (sleep
mode). Press the Standby button once again to switch the receiver to ON mode.
2.
On the transmitter, press and hold the Standby key for 3 seconds and the transmitter will go into Standby
(sleep mode).
3.
When there is no signal transmission sent from the HD device to the transmitter or receiver for one
minute, they will automatically enter light sleep mode. The link LED and video LED will turn OFF.
•
Setting the devices to standby mode reduces power usage by about 2.5W.
Indicates RED LED is lit
Transmitter
Status
Power
●
Power
●
Link
Standby
(sleep mode)
SETUP
Indicates GREEN LED is lit
Video
Link
Power
●
●
●
●
- 5 -
Receiver
Video
Link
●
●
Publicité
