Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14.5
Change the blade
When changing the blade are to protect your hands, wear appropriate gloves. Before the
spark plug is to be deducted.
Use to help a holding pen as a blocking device for the knife. The blade mounting screw has a
normal right hand thread. To loosen this screw is best to use a 17 mm socket wrench.
When reassembling the slip clutch on the exact order in which these components were previously
installed. The screw diameter must be attached to the specified torque of 40 Nm
Make sure that the cutting edges pointing in the direction in which the motor also rotates.
When replacing, use only cutter that match the original enclosed blade in quality and
size.
14.6
Sharpen knives
Note: To clean work with, you should raise it at regular intervals. (after about 25 hours)
The cutting blade can be sharpened with a metal file.
Even better is a sharpening / grinding in the customer service workshop. There is also paid particular
attention to the fact that is sanded off on each side the same amount, to avoid any imbalance.
The sharpening of the cutting edge may only be up to the impressed mark.
Use only original spare
also adversely affect your safety. Please contact your vendor for all required spare parts.
14.7
Chainging oil
The oil drain plug is located under engine, have a container ready
to catch the oil and remove the drain plug. We should incline
machine to make sure all the oil could be go out,Once the oil has
been emptied, replace the drain plug making sure that the washer
is in place and wipe clean any spillages.
Refill with 15W40 oil. When the dipstick is rested on the filler pipe
(i.e. not screwed in place), the oil lever must be between the Min
and Max marks on the dipstick. (See chapter fill with oil).
14.8 Spark Plug
Once the engine has cooled, remove the spark plug
using the box spanner supplied, clean the plug with a
wire brush. Using a feeler gauge, set the gap to 0.75
mm (0.030"). Refit the spark plug taking care not to
overtighten.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-DRM51
parts.
Parts of inferior quality can cause serious damage to the unit and may
MAINTENANCE
34
Publicité
Table des Matières
