Equinux tizi kraftprotz powerstart Mode D'emploi page 27

All manuals and user guides at all-guides.com
Kraftprotz
Tips and hints
Important safety information
Never connect the red jumper cable (+)
cable (–) together (short circuit). This could cause a fire!
Only suitable for cars with an on-board voltage of 12V!
When connecting the red (+) and black (–) starter cables make
sure NOT to switch them!
Never store your tizi Kraftprotz with the starter cables attached.
Always remove the starter cable from your Kraftprotz.
Boosting your car is normal wear and tear
Method „B. Quick jump start" is a high energy process which
strains the battery cells of the Kraftprotz when used on an
ongoing basis. The tizi Kraftprotz supports up to twenty quick
jumps in its product lifecycle as long as the starting power is not
over 200A. After which the capacity of the battery is permanently
worn. This is not a defect but instead normal wear and tear of the
product.
Method „A. Refresh" is the preferred, gentler method to protect
the life of the Kraftprotz battery.
Safe storage
Your Kraftprotz should not be stored in your car. There are
frequent extreme temperature difference in cars. Very low or high
temperatures could shorten the life of your Kraftprotz.
If the Kraftprotz is not used for an extended period of time, it's
best not to keep it fully charged. A fully charged, unused battery
EN
POWERSTART
and the black jumper
27
EN
EN