Equinux tizi kraftprotz powerstart Mode D'emploi page 24

All manuals and user guides at all-guides.com
Kraftprotz
B. Quick jump start your car
For this method, your Kraftprotz will be used directly to start your car.
Please adhere to the following steps:
Preparing your car
1. First check the battery status by a short press on the status
button . At least three status LEDs
not the case, you should use method „A. Refresh" instead.
2. Turn off your ignition, remove the key and be sure to turn off any
systems drawing power in your car (lights, heat, navigation, radio)
Continue under the hood
3. Attach the red jumper cable (+)
your car's battery or connect it to the jump start socket.
4. Attach the black jumper cable (
of your car's battery or connect it to the jump start socket.
5. Plug in the Jumper cable plug
you plug it in, charging will begin automatically.
Now it's time to start!
6. Start your car. Make sure to leave the starter on first for a couple
of seconds. If the motor does not start after three tries, please see
"Help".
Did your motor start? Remove your Kraftprotz from the battery.
7. First remove the black jumper cable (–)
jumper cable (+)
8. Detach the tizi jumper cable
EN
POWERSTART
should be lit. If this is
to the red positive pole of
) to the black negative pole
–
into your Kraftprotz
from the car battery.
from your Kraftprotz.
24
EN
. Once
and then the red
EN