Equinux tizi kraftprotz powerstart Mode D'emploi page 22

All manuals and user guides at all-guides.com
Kraftprotz
A. Refresh your car battery
For this recommended method, the Kraftprotz will charge your car's
battery for around 15 minutes before you start your car.
Please adhere to the following steps:
Preparing your car
1. First check the battery status by a short press on the status
button . des Kraftprotz' kurz drücken. At least two status LEDs
should be lit in order to have enough power to charge the car
battery.
2. Turn off your ignition, remove the key and be sure to turn off any
systems drawing power in your car (lights, heat, navigation, radio)
Continue under the hood
3. Attach the red jumper cable (+)
your car's battery or connect it to the jump start socket.
4. Attach the black jumper cable (
of your car's battery or connect it to the jump start socket.
5. Plug in the Jumper cable plug
you plug it in, charging will begin automatically.
Please be patient and give your Kraftprotz time to charge
6. You should leave the Kraftprotz attached for at least 10 to 15
minutes in order to ensure the battery has been charged enough.
The longer, the better.
Make sure to remove the Kraftprotz before you start your car.
7. First remove the black jumper cable (–)
jumper cable (+)
EN
POWERSTART
to the red positive pole of
) to the black negative pole
–
into your Kraftprotz
from the car battery.
22
EN
. Once
and then the red
EN