Télécharger Imprimer la page

FRANCO BELGE NF D 35-376 Instructions Pour L'installateur page 23

Masquer les pouces Voir aussi pour NF D 35-376:

Publicité

Les langues disponibles

Les langues disponibles

Réf. 124 13 04
3.6. Trouble Shooting
Problem
Fire difficult to start
Fire goes out
Fire burns too quickly
Smokes when lighting up
Smokes while burning
Low heat output
Notice de référence
Poêle mixte
Probable causes
Wood green, too damp or poor
quality fuel
Logs are too big
Air starvation
Insufficient draught
Too much draught
Excessive draw
Poor quality wood
Flue duct is cold
Room is in decompression
Draught is insufficient
Down draught
Room is in decompression
Incorrect Fuels
Document n° 729-4EN ~ 03/02/1999
þ
: This sign means that you should
asked for a qualified engineer to do the
- Corrective action
- Use the recommended fuel
- To light the fire, use small, very dry twigs. To maintain the
fire, use split logs
- Open lower spin wheel and top air control lever
þ
- Check that the flue is not obstructed, sweep it if
necessary
- Seek advice from a chimney specialist
- Ensure that the lower spin wheel is closed
- Partially close the top air control lever
þ
- Install a draught stabiliser. Consult your Dealer
- Do not continuously burn small wood, sticks, bundles,
carpentry offcuts (plywood, pallets), etc.
- Burn paper and kindling wood to increase heat
- In houses equipped with mechanical ventilation, partly
open a window until the fire is well established
þ
- Consult a chimney specialist.
- Check that the flue is not obstructed, sweep if necessary
þ
- Install an anti-down draught cowl. Consult your Dealer.
- In houses equipped with CMV, an outside air intake must
be installed for the chimney
- Use the recommended fuel
Burgundy
work.
23

Publicité

loading

Ce manuel est également adapté pour:

Nf d 35-301124 13 04