Publicité
Les langues disponibles
Les langues disponibles
6. MAINTENANCE
Regularly check the hose, dust bag and filter to prevent problems. Empty the hose when it
is clogged. Replace the dust bag when it is full and clean or replace the filters when they
are dirty.
Replacing the dust bag
Check that the vacuum cleaner is off and remove the plug from the socket before replacing
the dust bag or motor filter. Never use the vacuum cleaner without a dust bag or motor filter.
•
Replace the dust bag when the dust bag full indicator
bag seems to be full.
•
Open the dust bag compartment by pressing in the handle. Lift the cover and carefully
remove the full dust bag from the holder. Throw away the full dust bag.
•
Fold a new dust bag as shown and slide it in the dust bag holder.
•
Open the cover of the dust bag compartment. The opening of the dust bag is
automatically pushed on the correct location when the cover is being closed. The cover
of the dust bag compartment cannot be closed when the dust bag has not been placed
correctly. Place the dust bag once more, in accordance with the instructions.
Replacing or cleaning the motor filter
The motor filter must be replaced after every 5 dust bags. In between, it can be cleaned.
•
Remove the motor filter by sliding the holder upwards.
•
Place a new motor filter in the holder and slide it back or clean the motor filter with
lukewarm water and allow it to dry in the air for 24 hours before placing the motor filter
back in the holder.
Cleaning or replacing the HEPA filter
The HEPA filter cleans the air one more time before it is ejected by the vacuum cleaner.
Clean the HEPA filter at least once every six months or when it is very dusty. When the
HEPA filter is damaged, it must be replaced by a new original filter.
•
Press the clip to open the grille under which the HEPA filter is located.
•
Remove the HEPA filter.
•
Clean the HEPA filter with lukewarm flowing water and allow the filter to dry in the air
for 24 hours. Do not use cleaning agents or brushes.
•
Only place the HEPA filter back once it is fully dry, or place a new HEPA filter.
•
Place back the grille. Make sure it is properly attached.
Attention:
•
Only use the vacuum cleaner when the filters and a dust bag have been placed. If not,
the suction power could be reduced or the motor could be damaged.
•
Remove the plug from the socket before cleaning or replacing the filters.
•
Torn or not properly sealing filters could damage the motor. When a filter is defective, it
must be replaced by a new original filter.
•
The filters may not be cleaned in the dishwasher.
•
Do not use a hair dryer to dry the filters.
2 2
becomes red or when the dust
Publicité
