Publicité
Les langues disponibles
Les langues disponibles
5. USE
Check that the voltage stated on the information plate matches the voltage used in your
region.
Switching on the vacuum cleaner
1.
Place the vacuum cleaner on a sturdy and flat surface.
2.
Carefully pull the cord out of the vacuum cleaner and insert the plug in a power socket.
Do not pull the cord any further than the red mark.
3.
Adjust the telescopic tube to the required length.
4.
Switch on the vacuum cleaner by pressing the on/off button
5.
Depending on the surface to be cleaned, you can adjust the brushes in the floor nozzle.
When cleaning hard floors, you must make sure the brushes are extended.
When cleaning floor coverings or floor cloths, the brushes must be retracted.
6.
Depending on the surface to be cleaned, you can adjust the suction power. Slide the
suction power controller to the left or to the right between the min and max indications.
Minimum suction power:
Medium suction power:
Maximum suction power:
7.
When it is difficult to move the floor nozzle over the floor, you can adjust the suction
power with the min - max suction power controller or with the extra suction power
controller on the handle of the hose.
Switching off the vacuum cleaner
1.
Switch off the vacuum cleaner by pressing the on/off button
2.
Remove the plug from the socket, hold the plug and allow the cord to wind automatically
by pressing the button for automatic rewinding
your hand to prevent possible damage. The cord is automatically wound up in the
vacuum cleaner.
Storage
The vacuum cleaner can be stored in two ways. Standing on its rear side - parking position -
or its bottom side, so that the appliance takes up less space.
• Rewind the cord by pressing the button for automatic cord rewinding
• Slide the button on the top side of the tube upwards and push the top part of the tube
downwards to shorten the tube. When you let go of the sliding button, the tube will snap
tight.
• Slide the floor nozzle in the holder on the bottom side of the vacuum cleaner - parking
position - or place the vacuum cleaner upright and slide the floor nozzle in the holder on
the bottom side of the vacuum cleaner.
2 1
delicate materials, curtains
furniture, rugs and mattresses
tiles, wooden or other hard floors
with your foot. Guide the cord with
with your foot.
with your foot.
with your foot.
Publicité
