Kalkhoff IMPULSE EVO RS Notice Originale page 193

If the battery now stays on the charger, the charger
regularly checks whether the battery is still fully charged.
The charger LED starts to flash again. After checking and
ascertaining that the battery is full, the charger switches
back to "light continually".
6. Remove the power cable from the socket after completing the charging
process.
7. Remove the charging cable from the battery charging socket.
8. Fold down the protective battery cap.
10.3.1.1 Battery display during charging
Display Description
5 LEDs light up and no LED flashes

4 LEDs light up and the 5th LED flashes


3 LEDs light up and the 4th LED flashes


2 LEDs light up and the 3rd LED flashes
 
 1 LED lights up and the 2nd LED flashes

 1 LED flashes
10.4
10.4.1 Cleaning
DANGER
Always unplug the charger from the mains before cleaning and
especially before wiping it, otherwise you could get an electric shock
if you touch the contacts.
IMPORTANT
Do not immerse the charger in water. Damage may still result even
though the components are sealed.
Do not use any cleaners which contain alcohol or solvent, or which
scour. No coarse sponges or brushes may be used either. They leave
scratches and cause the surface to become matt. Clean the charger
Battery charge level
with a soft damp cloth.
100 – 97%
80 – 96%
1. Remove the charging cable from the battery charging socket.
60 – 79%
2. Unplug the charger from the mains socket.
40 – 59%
3. Clean the casing with a slightly damp, soft cloth.
20 – 39%
0 – 19%
4. If the contacts are dirty, clean them with a soft dry cloth.
10.4.2 Storage
1. Store the battery charger in a dry, not excessively warm room. The
charger should not be exposed to direct sunshine. The recommended
storage temperature range is 18 bis 23 ˚C.
Tips
Original User Guide | Pedelec Impulse Evo RS Version 2 EN-91