Télécharger Imprimer la page

Atag KD85102AD Mode D'emploi page 76

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION AND CONNECTION
The kitchen unit in which the appliance is to be built in must have an opening of at least
200 cm
in its base to allow sufficient air to circulate.
2
The appliance's air outlet is at the top. Make sure that the outlet is not blocked. Blocking the
outlet can result in damage to the appliance.
Warning:
An anti-condensation accessory must be installed before built-in appliances are installed
next to each other in a cupboard or surround. For safety reasons, this must be
installed by a recognized installer!
Connecting the appliance
Connect the appliance to the power supply with a plug. The socket must be earthed. The
nominal voltage and frequency required for the appliance are shown on the appliance's type
plate/label with basic information.
The appliance must be connected to the mains and earthed in accordance with the
prevailing standards and regulations. The appliance can withstand small variations in the
mains voltage to a maximum of plus or minus 6%.
When you are not going to use the appliance for a longer period then switch it off with
the appropriate key and disconnect it from the mains. Empty, defrost and clean the
appliance, and leave the door ajar.
Freeze burn hazard
To avoid freeze burn, never put frozen food in your mouth and do not touch frozen food.
In the event of a defect or power cut, do not open the freezer compartment unless the
appliance has been out of operation for more than the hours indicated on the appliance's
type plate (temperature rise time). After this time, you must either use the frozen food or
make sure that it is properly cooled (for example, by transferring it to another appliance).
EN 12

Publicité

loading