ARDES AR4P04RG Mode D'emploi page 19

Wait 30 seconds until the fan will stop; then switch off the appliance
by setting the main switch (6) to "0".
"Mode" button
When the device is switched on, press this button to change the operating
mode:
- ventilation (indicator "Fan");
- minimum heating (indicator "Low");
- maximum heating (indicators "High").
"SWING" button
Press this button to activate or deactivate the automatic swing function
of the device. When the swing function is active, the corresponding
indicator (8) lights up.
"TIMER" button (D)
Press the TIMER button when the device is working to program
automatic switch-off at an interval of between 1 to 12 hours from when it
is programmed. Every time the button is pressed, the interval increases
by one hour.
A few seconds after selecting the timer, the display (2) will show the room
temperature again.
When the timer function is activated, the indicator (7) lights up on the
control panel. To disable the timer function, press the timer button
repeatedly until the display shows "0 0".
"Tem" button (control panel)
"UP +" "DOWN -" buttons (remote control)
Press one of these buttons to set the desired room temperature
(automatic function); the set temperature will flash on the display (2).
Press button "+" to increase the temperature or button "-" to decrease it:
the set temperature will change from a minimum of 15°C to a maximum
of 40°C.
Once the desired temperature has been selected, the display (2) will
show the room temperature after a few seconds.
In automatic mode, the device will automatically regulate the heating
power based on the difference between the room temperature and the set
temperature. In this operating mode, the device will also switch between
the various power levels (ventilation, low power, high power) repeatedly.
The selected power level is always shown on the display. Once the set
temperature has been reached, ventilation will still remain active in order
to monitor the room temperature more effectively.
To disable this function, press the "MODE" button and manually select
the desired function (ventilation only, low power or high power).
19