Publicité
Les langues disponibles
Les langues disponibles
2. Separate the water supply line from
the refrigerator
1. Remove one or two water lines, depending on
the model, by pressing each coupler ( 1 ) and
pulling the water lines ( 2 ) away.
Your refrigerator may have one or two
water lines, depending on the model.
If it has two, the lines are different colors.
Make sure you match the colors when you
re-attach them.
CAUTION
Do not cut the water line.
Gently separate it from the coupler.
3. Remove the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
• Is necessary, have two people disassemble the
doors.
DA68-02981E-01.indb 12
1. With the Freezer door closed, remove the
upper hinge cover ( 1 ) using a screwdriver,
and then disconnect the wires by gently pulling
them apart ( 2 ).
(1)
(1)
Be careful not to damage the sensor
harness with the hinge cover.
(2)
2. Remove the hinge bolts ( 3 ) with a 10 mm
Socket Wrench.
Remove the ground screw ( 4 ) by turning it
counter-clockwise.
Take off the upper hinge ( 5 ) in the direction of
the arrow.
Take care that the door does not fall on you.
3. Open the Freezer door, and then remove the
door from the lower hinge ( 6 ) by carefully lifting
it up ( 7 ).
English - 12
(2)
(4)
Pressing
(3)
(5)
(7)
(6)
14. 1. 20.
7:48
Publicité
