Husqvarna HD725E Manuel De L'opérateur page 5

TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
VINYL
BINDINGS
INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
TO PREPARE BATTERY (See Fig. 5)
NOTE: Your battery must be charged before you can start
your lawn mower.
1. Open battery box.
2. Con nect battery charger con nec tor (male) to harness
con nec tor (fe male).
3. Plug battery charger into 110 volt A.C. outlet.
4. Leave battery charger connected for 24 hours before
starting your engine for the fi rst time.
5. After charging, disconnect harness connector (female)
from bat tery charger connector (male).
Connect your battery charger to charge battery as re quired.
IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR
BATTERY.
At the end of the mowing season the battery should be
charged for 48 hours to protect the battery during winter
storage.
CAUTION: Always disconnect the har-
ness connector to prevent ac ci den tal
start ing when transporting or stor ing
your lawn mower after the season.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
ASSEMBLY
FRAME
HANDLE
FRAME
OPENING
FIG. 3
ROPE GUIDE
BATTERY CHARGER
HARNESS
CONNECTOR
(FEMALE)
BATTERY
BOX
mulcher. To convert mower to bagging or discharging,
see "TO CON VERT MOWER" in the Operation section of
this man u al.
5
CONTROL BAR
UPPER
HANDLE
T-KNOB
ENGINE
STARTER
ROPE
FIG. 4
CHARGER
CONNECTOR
(MALE)
FIG. 5