Agri-Fab SpeedEPart 45-0320 Notice D'utilisation page 9

4. (Figure 15) Turn the second rear hopper tube so that the (Figure 15) (Figure 15) Turn the second rear hopper tube so that the
brace holes in the middle of the tube face up. Assemble
the ends of the rear hopper tube onto the ends of the
lower hopper side tubes. Fasten together using plastic
plugs (CC).
REAR HOPPER TUBE
(brace holes on top)
PLASTIC PLUG (CC)
LOWER
HOPPER
SIDE TUBE
5. (Figure 16) Place the assembled lower hopper tubes (Figure 16) Place the assembled lower hopper tubes (Figure 16)
into the bottom of the hopper bag
6. (Figure 16) Attach the ends of the lower hopper side (Figure 16) Attach the ends of the lower hopper side (Figure 16)
tubes to the inside of the upper hopper side tubes using
two 3/8" x 1/2" clevis pins (S) inserted from the inside,
and two 3/32" hair cotter pins (R).
LOWER HOPPER
SIDE TUBE
UPPER HOPPER
SIDE TUBE
3/32" HAIR
COTTER PIN (R)
3/8" x 1/2"
CLEVIS PIN (S)
HOPPER BAG
BOTTOM
ENGLISH
7. (Figure 17) Insert the bag frame strap into the stitched (Figure 17) Insert the bag frame strap into the stitched (Figure 17)
sleeve along the front edge of the bag bottom.
8. (Figure 17) Assemble the bag frame strap to the lower (Figure 17) (Figure 17) Assemble the bag frame strap to the lower
hopper side tubes using two 1/4" x 1-1/8" clevis pins
(T) and 3/32" hair cotter pins (R).
15
BAG FRAME STRAP
1/4" x 1-1/8"
CLEVIS PIN (T)
9. (Figure 18) Secure the bag corners around the lower (Figure 18) Secure the bag corners around the lower (Figure 18)
hopper side tubes by snapping the bag fl aps to the bag
bottom on both sides.
16
SNAP
9
17
3/32" HAIR
COTTER PIN (R)
18
FLAP