Agri-Fab SpeedEPart 45-0320 Notice D'utilisation page 8

17. (Figure 12) Position the height adjustment handle side (Figure 12) (Figure 12) Position the height adjustment handle side
to side so that the tooth lock washer (P) can fi t between
the handle and the height adjustment strap. Tighten the
nuts securing the height adjustment handle.
18. (Figure 12) Insert the 5/16" x 1" carriage bolt (E) through (Figure 12) Insert the 5/16" x 1" carriage bolt (E) through (Figure 12)
the height adjustment handle. Assemble onto the bolt,
in order, the 5/16" tooth-lock washer (P), the height
adjustment strap, a 5/16" fl at washer (M) and the plastic
knob (AA).
5/16" FLAT
WASHER (M)
PLASTIC
KNOB (AA)
TOOTH LOCK
WASHER (P)
12
5/16" x 1"
CARRIAGE BOLT (E)
ENGLISH
ASSEMBLY OF HOPPER BAG
1. (Figure 13) Turn a rear hopper tube so that the brace (Figure 13) (Figure 13) Turn a rear hopper tube so that the brace
holes in the middle of the tube face down. Slide the
tube through the two loops sewn to the top rear seam
inside the hopper bag.
2. (Figure 14) Insert the two upper hopper side tubes (Figure 14) (Figure 14) Insert the two upper hopper side tubes
through the stitched fl aps on each side of the hopper
bag.
3. (Figure 14) Assemble the ends of the rear hopper tube (Figure 14) (Figure 14) Assemble the ends of the rear hopper tube
onto the ends of the upper hopper side tubes. Fasten
together using plastic plugs (CC).
8
INNER BAG LOOPS
REAR HOPPER TUBE
(brace holes on bottom)
PLASTIC PLUG (CC)
UPPER HOPPER
SIDE TUBE
13
14