Worx WG545E Traduction Des Instructions Initiales page 14

CLEAninG THE TOOL
Clean the tool regularly.
wARNING: Keep your product dry.
Under no circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
wARNING: Do not use any type of
detergent, cleaner or solvent which
may contain chemicals that could seriously
damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
EnViROnMEnTAL
PROTECTiOn
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
14
Cordless Li-ion Blower/Sweeper
PLUG REPLACEMEnT
(UK & iRELAnD OnLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows. The wire
which is coloured blue must be connected to
the terminal which is marked with N. The wire
which is coloured brown must be connected
to the terminal which is marked with L.
wARNING: Never connect live or
neutral wires to the earth terminal of the
plug. Only fit an approved 13A BS1363/A plug
and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
En