Tanita innerScan RD-953 Guide De Démarrage Rapide page 3

Place the monitor on a hard, flat surface where there is minimal vibration to ensure safe and
accurate measurement.
Avoid excessive impact or vibration to the monitor.
Doing so may damage the monitor or cause it to malfunction,or may cause setting to be erased.
Do not use or store this monitor in the following locations.
·Locations that are exposed to direct sunlight, near to heaters, or exposed directly to air from air conditioning units,
etc.
·Locations where there are severe temperature changes or a large amount of vibration.
·Locations with high levels of humidity or moisture
Doing so may damage the monitor or cause it to malfunction.
Do not step on the monitor when your body is wet (immediately after a shower or bath, etc.)
Be sure to thoroughly dry your body and feet before using the monitor. Failure to do so may cause you to slip or
fall, resulting in injury. Also, the monitor cannot take accurate measurements if your body or feet are wet.
Keep away from water.
Do not use boiling water, benzene, thinner, etc. to clean the monitor.
Always...
If the monitor becomes dirty, soak a soft cloth in water or neutral household detergent, wring it out thoroughly and
wipe the monitor clean, then use a dry cloth to wipe the monitor dry.
Do not attempt to disassemble the monitor. Do not modify this equipment in any way.
Do not wash the monitor in water.
Do not submerge this monitor in water.
Doing so may damage the monitor or cause it to malfunction.
Be sure to insert the batteries with the polarities (+, -) in the correct position.
If the batteries are incorrectly inserted, battery uid may leak and damage the oor. (If you do not intend to use
this monitor for a long period of time, it is advisable to remove the batteries before storage.)
Do not use the monitor near other products such as microwave ovens that emit electromagnetic waves.
Doing so may cause the monitor to malfunction, preventing accurate measurements.
Another person should assist persons with disabilities who may not be able to take a measurement
alone.
Getting Accurate Readings
To ensure accuracy, readings should be taken without clothing and under consistent conditions of hydration. If you do not undress,
always remove your socks or stockings, and be sure the soles of your feet are clean before stepping on the measuring platform. Be
sure that your heels are correctly aligned with the electrodes on the measuring platform. Don't worry if your feet appear too large for
the unit accurate readings can still be obtained if your toes overhang the platform. It is best to take readings at the same time of day.
Try to wait about two hours after rising, eating, or hard exercise before taking measurements. While readings taken under other
conditions may not have the same absolute values, they are accurate for determining the percentage of change as long as the readings
are taken in a consistent manner. To monitor progress, compare weight and body fat percentage taken under the same conditions
over a period of time.
An accurate reading will not be possible if the soles of your feet are not clean, or if your knees are bent or you are in a sitting position.
Note
Preparations before Use
Insert the batteries
Please note that the included
batteries from factory may
have decreased energy levels
over time.
Up Button
Down Button
Set your location code
Different locations across the world have different gravitational pulls. These differences affect
the accuracy of the weight measurement. You can obtain the most accurate weight readings
by selecting the correct gravity setting on the scale according to your geographical location.
1.When the power is off, press and hold the button.
2.Refer to the map enclosed, and press the buttons to select your location code.
3.Press the button to enter and save the setting.
SET Button
Off Button
3