Dell PowerVault MD3200i Guide De Mise En Route page 20

LED Indicators
Front panel
Hard-drive carrier
Power supply/cooling fan
RAID controller module
Switch
System identification button
Enclosure mode switch
Password reset switch
18
Getting Started With Your System
All manuals and user guides at all-guides.com
• One two-color LED indicator for system status
• Two single-color LED indicators for power and
enclosure mode
NOTE:
The enclosure mode LED is not applicable to
the PowerVault MD3200i series storage array.
• One single-color activity LED
• One two-color LED status indicator per drive
Three LED status indicators for power supply status,
power supply/fan fault, and AC status
Ten single-color LEDs:
• One battery fault
• One cache active
• One controller fault
• One controller power
• One system identification
• One management Ethernet activity
• Four iSCSI IN port activity
Six two-color LEDs:
• Four iSCSI IN link speed
• One SAS OUT link or fault
• One management Ethernet link speed
Located on the front control panel. This button is
used to locate a system within a rack.
Located on the front of the system. This switch is
not applicable to the PowerVault MD3200i series
storage array.
Located on the back panel of the RAID controller
module. This switch is used to reset the storage array
password.