4.8 Adjusting the Shock Absorber
CAUTION!
Make sure controller is turned off.
1. Prop up the chassis so the wheels are no longer
supported. (Fig. 4.6).
Fig. 4.6
3. Remove shock absorber cover by applying upwards
pressure to the bottom of the cover and simultaneously
pulling the cover towards you (Fig. 4.8).
Fig. 4.8
5. Undo the 2, M6 screws which secures the fender (Fig. 4.10).
Fig. 4.10
12
2. Undo the 3 nuts and remove drive wheel (Fig. 4.7).
4. Undo the M8 nut and remove screw M8x45 which secures
the top of the shock absorber (Fig. 4.9).
6. Manipulate the shock absorber and the fender and remove
the fender from the assembly (Fig. 4.11).
Fig. 4.7
Fig. 4.9
Fig. 4.11
Q500 M/F/R/H Rev.D