Charging The Batteries - Sunrise Medical Breezy PowerSupport Notice D'utilisation

Operating instructions
2.2

Charging the batteries

The PowerSupport may be charged at any time. The charging process may also be
interrupted at any time. As soon as the battery charger is connected to the
PowerSupport, the battery indicator will show the battery condition. During charging
the PowerSupport is protected and it is not possible to drive with PowerSupport
assistance.
During charging one of the battery indicator lights will flash. The battery charge level
can be recognized by the number of lights that are constantly lit. When the battery is
fully charged, all indicator lights will stay on.
1. Put the charge cable of the battery charger in the wall outlet of the electricity
mains.
2. Remove the cover cap from the battery pack.
3. Put the four-pin charge plug of the battery charger in the battery pack until you
hear a clear 'click'.
4. Check if a battery indicator light on the controller is flashing when you start
charging the batteries. This indicates that the batteries are actually being charged.
5. After charging, check if the battery indicator lights on the controller are
permanently lit. This indicates that the batteries have been charged properly.
6. Push back the release catch and remove the charge plug of the battery charger
from the battery pack. Attention: the charge plug cannot be removed from the
battery pack if the release catch is not pushed in. This may damage the
electronics.
7. Put the cover cap of the battery pack back in place.
8. The PowerSupport is now ready for use.
It is advised to mount a smoke detector in the charging area.
Disconnect batteries in case of longer storage without usage.
18