Slope; Obstacles - Sunrise Medical Breezy PowerSupport Notice D'utilisation

Operating instructions
2.8

Slope

Only drive with PowerSupport assistance on slopes you are familiar with. Slopes with
an angle of more than 6° are not suitable for the PowerSupport.
The top 3 positions are suitable for driving on a slope with assistance.
Driving up a slope
•
Stop before the slope.
•
Before driving up the slope, put the selector switch in a position providing sufficient
assistance (preferably position 4/5).
•
If necessary change to a higher position if you feel the selected position is not
providing sufficient assistance.
•
Avoid neutral (off mode) and reverse (R). In these positions the wheelchair does not
brake so the attendant receives the full weight.
Driving down a slope
•
Stop before the slope.
•
Before driving down the slope, put the selector switch in the forward position (1-5).
Do not use the operating handle, but push the wheelchair down the slope by
yourself. The motors will brake slightly if the speed exceeds 3 km/h.
•
Avoid neutral (off mode) and reverse (R). In these positions the wheelchair does not
brake so the attendant receives the full weight.
Attention: with a user weight of more than 100 kg the wheelchair will hardly
brakes, if at all.
2.9

Obstacles

The PowerSupport is suitable for kerbs up to 4 cm. Drive carefully towards the kerb
with the front wheels. Put the PowerSupport in position 4 or 5. Then take a short run
up (15 cm) to drive up the kerb. Make sure the wheelchair does not carry on
accelerating after mounting the kerb.
20