Publicité
Les langues disponibles
Les langues disponibles
KB310-SSWM
Installation Instructions
Fig. 8
Fig. 9
Fig. 10
Fig. 11
*Diagrams are not to scale.
Step 7:
• With the unit open take the liner dispenser and
position it over the exposed metal frame in the
center of the flange.
• Use the provided key to open the liner dispenser.
This will provide access to the four mounting holes.
• Use the provided hardware to secure the liner
dispenser to the metal frame. Fig. 8
• Lock the liner dispenser and close the unit.
Step 8:
• Take one of the provided handles and position it
over the handle mounting studs, so that the open
portion is toward the top of the unit.
• Use provided Allen wrench to tighten the set screws
in the handles, securing it to the handle mounting
studs. Fig. 9
• Repeat for the opposite handle.
Step 9:
• Test the unit by opening and closing multiple times,
ensuring it opens and closes smoothly.
• Remove protective film from the surface of the unit.
Step 10:
• To install the bag hook, measure up 44" (1118mm)
from finished floor in the desired location and mark
the wall.
• Position the bag hook on the wall so that the top of
the mounting plate is level with the 44" (1118mm)
mark.
• Position the bag hook over a wall stud for optimal
strength.
• Mark then predrill the mounting holes. Fig. 10
• Use the provided screws to secure the bag hook in
position, then take the escutcheon plate and screw
it over the mounting plate to cover the mounting
screws. Fig. 11
7
7
Publicité
