Publicité
Les langues disponibles
Les langues disponibles
KB310-SSWM
Installation Instructions
Fig. 1
Fig. 2
Fig. 3
1/8"
(3mm)
49 13/16"
(1265mm)
*Diagrams are not to scale.
Skirt
Flange
16"
(406mm)
Step 1:
• Be sure to wear safety gloves to protect your hands
from the products exposed metal edge.
• Remove the handles and bag hook from the
packaging and set to one side.
• For Masonry or Tile over Stud Wall:
Use a 1/4" (6mm) masonry drill bit for the pilot hole
until you hit the stud. Change bit to 1/8" (3mm)
regular drill bit.
• For walls with Metal Studs, Concrete Block:
If the wall has wood studs that are not on 16"
(406mm) centers, has metal studs or an underlying
surface of concrete block, you may have to
purchase toggles before installing. You must allow
a minimum clearance inside wall space for toggles
to turn depending on toggles used. Follow toggle
manufactures instructions for installation.
Step 2:
• Remove the main unit from the flange by lifting it
out and set to one side, face down on a protected
flat surface. Fig. 1
• Lift the flange out of the skirt and set to one side.
Fig. 2
Step 3:
• Measure up the wall 49 13/16" (1265mm) and mark
the desired mounting location on wall stud center.
Fig. 3
• Measure across 16" (406mm) and use a level to
mark for the second mounting location. The skirt
has two hangers set on 16" (406mm) centers for
easy installation.
• Predrill and screw in the provided mounting screws,
make sure to leave ~1/8" (3mm) of the thread
exposed.
• Position the hangers over the screws and hang the
skirt. Make sure to check it is level before securing
the mounting screws.
5
5
Publicité
