Wolf E Serie Manuel D'installation page 4

SPECIFICATIONS
Installation Requirements
The E series oven can be installed in a standard or flush
inset application. If a cooktop is being installed above an
oven, a minimum of 1 / " is required between units. Loca-
(6)
4
tion of the electrical supply within the oven opening may
require additional cabinet depth.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Single Oven
Double Oven
TRIM OVERLAP
Top
Bottom
Sides
|
4 Wolf Customer Care 800.222.7820
COMBINATION INSTALLATIONS
Wolf built-in ovens are designed and agency approved for
installation with Wolf cooktops, microwaves and warming
drawers only. The nominal width of the oven should match
the nominal width of the cooktop. A built-in oven cannot be
installed below a Wolf rangetop.
For typical combination installations, refer to the Wolf
Design Guide.
The single oven may be installed next to another E series
1 / " reveal is single oven. You must allow for a 1
(6)
4
oven openings. A separate inner wall is required for each
oven between openings.
MIN
250 lb
(115 kg)
400 lb
(181 kg)
1
/ "
(13)
2
1 / "
(3)
8
11 / "
(17)
16
1 / " space between
(38)
2