Wolf E Serie Manuel D'installation page 10

INSTALLATION
Preparation
Before moving the oven, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift the oven by the door handle. This will
damage the oven door and hinges.
OVEN DOOR REMOVAL
To lighten the load or to fit through a door way, the oven
door(s) can be removed. Only remove if necessary. Door
removal should only be done by a certified installer or
service technician.
To remove, open the door completely. Rotate both hinge
latches forward to the open position, then lift the door up
and out. Refer to the illustration below.
To reinstall, insert door hinges into the frame openings, then
rotate hinge latches to the closed position.
CLOSED
OPEN
Oven door removal.
|
10 Wolf Customer Care 800.222.7820
Electrical Connection
WARNING
Verify power is disconnected from the electrical box
before proceeding.
With the oven positioned directly in front of the opening,
feed the conduit through the opening in the cabinet platform
(if applicable). Depending on local codes, connect the oven
to the electrical supply following these steps for a three-wire
or four-wire system:
Connect the black appliance wire to the black (L1) power
1
supply wire in the electrical box.
Connect the red appliance wire to the red (L2) power
2
supply wire in the electrical box.
Connect the ground appliance wire to the green/ground
3
house grounding wire in the electrical box.
For a four-wire system, leave the white neutral wire in the
4
house electrical box unconnected. Seal with a wire cap.