Toro e-Dingo 500 Manuel De L'utilisateur page 9

Installing and Removing
the Blade Assembly
Service Interval: Before each use or daily—Lubricate
the blade-holder assembly shaft.
CAUTION
The blade assembly is heavy. Hands or other
body parts could be crushed.
Use caution when installing the assembly.
WARNING
The scraper blade is sharp and can cut your
hands.
Wear heavy leather or cut resistant gloves
and move tools away from the blade edge
when installing or removing the blade.
Installing the Blade Assembly
Refer to Selecting a Blade (page 9)
appropriate blade for the application.
1. Park the machine on a level surface.
2. Raise the attachment a few inches off the
ground for easier access.
3. Engage the parking brake, shut off the machine,
and remove the key.
4. Lubricate the shaft of the blade-holder assembly,
then install it into 1 of the 3 tubes on the
attachment. Secure it with a locking pin.
Note:
Use the side tubes when removing
flooring close to vertical surfaces, such as walls.
1. Locking pin
to select the
Figure 3
2. Blade-holder assembly
5. Loosen the 4 bolts on the blade-holder clamp
2 turns counterclockwise. Do not remove the
bolts.
WARNING
Removing the bolts can cause the clamp
to not securely hold the blade, which can
slip and injure you.
Only loosen the bolts; do not remove
them.
1. Bolt (4)
6. Carefully torque the bolts to 271 N∙m (200 ft-lb).
g371150
7
Figure 4
2. Blade
g371151