Toro e-Dingo 500 Manuel De L'utilisateur page 10

Removing the Blade Assembly
1. Park the machine on a level surface and engage
the parking brake.
2. Raise the attachment a few inches off the
ground for easier access.
3. Shut off the machine, and remove the key.
4. Loosen the 4 bolts on the blade-holder clamp 2
turns counterclockwise.
WARNING
Removing the bolts can cause the clamp
to not securely hold the blade, which can
slip and injure you.
Only loosen the bolts; do not remove
them.
1. Bolt (4)
5. Remove the blade
Figure 5
2. Blade
6. Remove the locking pin and the blade-holder
assembly.
1. Locking pin
g371177
8
Figure 6
2. Blade-holder assembly
g371176