Installation Steps
Locate the fasteners that attach the rubber seal to the underside
of the hood. Remove and discard. Honda CRV shown.
3
Insert (1) fastener and push into place with a phillips head screwdriver. Do not attempt to screw into place as additional force is needed to
5
6
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
properly seat fastener. Repeat for remaining (3) fasteners.
hood shield
hood
seal
fastener
Lower hood.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
Align Hood Shield with holes in hood. The mounting flange of the hood
shield is positioned UNDER the rubber trim.
4
7
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
Apply bump ons.