Balboa VL600S Manuel D'utilisation page 19

HOW TO USE YOUR SPA
Sensors are out of
The temperature sensors MAY be out of
sync by 3°F.
sync – M015
Sensors are out
The temperature sensors ARE out of sync.
of sync -- Call for
service – M026
Sensor A Fault,
A temperature sensor or sensor circuit has
failed.
Senor B Fault –
Sensor A: M031,
Sensor B: M032
Communications
The control panel is not receiving
communication from the System.
error
Test software
The Control System is operating with test
software.
installed
Program memory At Power-Up, the system has failed the
Program Checksum Test.
failure – M022
The settings
have been reset
(Persistent Memory
Error) – M021
The clock has failed
– M020
Configuration error
(Spa will not Start
Up)
A pump may be
Water may be overheated.
stuck on – M034
Hot fault – M035
A Pump Appears to have been Stuck
ON when spa was last powered POWER
DOWN THE SPA.
** Some messages can be reset from the panel. Messages that can be reset will appear with a Clear
Icon at the bottom of the Message Screen. Press the Clear Icon text to reset the message.
Call for Service if this message does not disappear
within a few minutes.
The fault above has been established for at least 1
hour.
Call for Service.
See: **.
If the problem persists, contact your vendor or a
service engineer.
See: **.
If the problem persists, contact your vendor or a
service engineer.
If the problem persists, contact your vendor or a
service engineer.
This indicates a problem with the firmware (operation
program) and requires a service call.
See: **.
Contact your service organization if this message
appears on more than one power-up.
See: **.
If the problem persists, contact your vendor or a
service engineer.
See: **.
If the problem persists, contact your vendor or a
service engineer.
POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
DO NOT ENTER THE WATER.
If the problem persists, contact your vendor or a
service engineer.
ENG
19