Germ Guardian AC4000 Utilisation Et Instructions D'entretien page 2

AC4000REV1108: Hygia 4.0 3L rev.
INTRODUCTION
Thank you for purchasing the Germ Guardian
Air Cleansing System. Please read and save these instructions.
SAFETY PRECAUTIONS
Please read the following precautions carefully before operating the
Table Top Complete Air Cleansing System. Failure to do so could result in
a fire hazard, electrical shock, bodily injury or damage to the unit.
WARNING: THE CORDS, WIRES AND/OR CABLES SUPPLIED WITH THIS PRODUCT
CONTAINS CHEMICALS, INCLUDING LEAD OR LEAD COMPOUNDS, KNOWN TO THE STATE
OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM. WASH HANDS AFTER USING.
• Do not damage, pull, twist, bend or place heavy objects on the
electrical cord.
• Never handle the electrical cord with wet hands.
• Do not alter the plug in any way.
• Do not use with extension cords.
• Never tug on the electrical cord to unplug the unit from the outlet.
• Unplug the unit before cleaning, installing or replacing filters.
• If the electrical cord becomes damaged, please contact a qualified
technician for repair.
• Do not place fingers or foreign objects into the airflow openings of
the unit.
• Operate the unit in a well-ventilated area.
• Do not operate unit with any other power supply other than the
one provided.
• Do not operate the unit outdoors.
• Do not operate near flammable gases.
• Do not operate the unit in humid or wet places such as a bathroom.
• Do not use chemical sprays near the unit, they will accumulate on the
filter and potentially cause harmful fumes.
• Do not operate the unit in an area with high oil content, such as
mechanical oil or cooking oil, over time it will deteriorate the filter.
• Never look directly at the UV-light bulb when lit.
• Make sure all filters are correctly installed before running the unit.
• This is not a toy and is not intended for use by children. For adult
use only.
• Do not defeat interlock switch.
E-2
All manuals and user guides at all-guides.com
11/11/08 3:29 PM Page 2
Table Top Complete
™
IDENTIFICATION OF PARTS
Main Unit
1. Control Panel
2. Vent Adjustment Lever
3. Filter
1
4. Filter Door
5. Filter Release Button
2
6. Ionizer
7. Power Supply Input
3
8. Power Supply (see note)
4
9. UV-Bulb
8. Power Supply
Modification not approved by the party responsible for compliance could void user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1 Reorient or relocate the receiving antenna.
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4 Consult the dealer or an experienced radio/TV technician for help.
Control Panel
A. On/Off
B. High Fan Speed
C. Low Fan Speed
D. Ionizer On/Off
A
B
8
7
9
5
6
D
C
E-3