ITT Goulds Pumps AquaBoost II 3AB2 Installation, Exploitation Et Maintenance page 5

3. System Design
Note
Systems MUST be designed by qualifi ed technicians only and meet all applicable state and local
code requirements.
The following fi gures show a typical constant pressure system using the AquaBoost II Controller. Connection
can be made directly to a water supply or water can be drawn from a supply tank. Figure 1 shows a typical set
up for a supply tank fed by a well.
Circuit
Breaker
Disconnect
Figure 1
System Layout
for supply tank
Figure 2 shows a set-up for boosting the pressure of an existing water supply. Both confi gurations allow pump
maintenance without main line shut-off.
Home Supply
Disconnect
Figure 2
System Layout for
municipal hook-up
Note
Fittings and valves are not included with AquaBoost controllers.
Home Supply
AquaBoost
Controller
Transducer
Gauge
Tank
Motor/Pump
AquaBoost
Controller
Circuit
Breaker
Gauge
Tank
Motor/Pump
Check Valve
Isolation Valves
Unions
Relief
Valve
Check Valves
To Drain
Check Valve
Isolation Valves
Unions
Transducer
Relief
Valve
Check Valve
To Drain
5
Well Supply
Atmospheric
Storage Tank
Water Main