Publicité
Les langues disponibles
Les langues disponibles
Do not allow dust to get into your mouth, eyes or lay on the skin.
Wear protective clothing whenever possible.
• The label on your tool may include the following symbols.
V............volts
Hz..........hertz
min ........minutes
......direct current
.......... Class II Construction
..........safety alert symbol
Motor
Your D
WALT tool is powered by a D
E
power supply agrees with the nameplate markings.
Voltage decrease of more than 10% will cause loss of power and
overheating. All D
WALT tools are factory tested; if this tool does not
E
operate, check your battery pack.
Side Handle (Fig. 1)
CAUTION: Always use side handle and hold rotary hammer
with both hands. It clamps to the front of the gear case as shown in
Figure 1 and can be rotated 360˚ to permit right or left hand use.
FIG. 1
A
All manuals and user guides at all-guides.com
A ..............amperes
W ..............watts
............alternating current
n o ............no load speed
.............. earthing terminal
.../min ........revolutions per minute
WALT-built motor. Be sure your
E
C
B
Variable Speed Switch
To turn the tool on, squeeze the trigger switch (B). To turn the tool off,
release the trigger switch. Your tool is equipped with a brake. The
chuck will stop as soon as the trigger switch is fully released.
The variable speed switch enables you to select the best speed for a
particular application. The farther you squeeze the trigger, the faster
the tool will operate. Use lower speeds for starting holes without a
centerpunch, drilling in metals or plastics, driving screws and drilling
ceramics. For maximum tool life, use variable speed only for starting
holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Forward/Reverse Control Button
A forward/reverse control button (C)
determines the direction and also serves
as a lock off button. To select forward
rotation, release the trigger switch and
depress the forward/reverse control
button on the right side of the tool.To
select
reverse,
depress
forward/reverse control button on the left
side of the tool. The center position of
the control button locks the tool in the off
position. When changing the position of the control button, be sure the
trigger is released. NOTE: The first time the tool is run after changing
the direction of rotation, you may hear a click on start up. This is normal
and does not indicate a problem.
Function Selector (Fig. 2)
For straight drilling, align the dial with the drill bit symbol (A). For rotary
hammer, align the dial with the symbol (B). To select chipping align the
dial with the hammer symbol (C). NOTE: The selector must be in either
drill, or hammer/drill or hammer mode at all times. There are no
operable positions in between.
7
FIG. 2
B
A
C
the
Publicité
