Zepter AqueenaPro WT-100 Manuel D'utilisation page 14

EN
Installation, servicing, maintenance and repairs should only be performed by
Zepter authorised staff.
All maintenance should be performed using original Zepter replacement cartridges and spare parts.
12
All manuals and user guides at all-guides.com
ITEMS IN THE BOX
1. AqueenaPro water fi ltration system
2. RO membrane in protective fi lm
3. Power supply adaptor
4. User manual
5. Drinking water faucet
6. Tube
7. Drainage clamp
8. Wrench for membrane housing
9. Accessory bag
a) Inline feed water connector
b) Clip for quick connectors
c) Faucet fi xture
AQUEENAPRO INSTALLATION
Warning!
• Avoid exposure to direct sunlight and installation in damp areas
It may create a breeding ground for microorganisms resulting in reduced purifi ed
water quality, as the internal components of the water purifi er can be polluted
• Inlet water cannot exceed 38°!
Using a hot water source (>38°C) will cause permanent damages to the RO
membrane and severely degrade the performance of the product.
Make sure that AqueenaPro is connected to a cold water supply only.
• The maximum distance between the water source and the
purifi er should not be more than 3 m.
• Avoid sharp bends in the pipe. Do not bend or block the
reject water tube.
• Do not confi ne your AqueenaPro in a tight cabinet.
• Do not use the AqueenaPro when the drain is clogged up.
• Do not use AqueenaPro at temperatures below 5°!
If the room temperature is below 5°, it can result in pipes cracking due to water
freezing inside the machine.
1 piece
1 piece
1 piece
1 piece
1 piece
5 m
1 piece
1 piece
1 piece
1 piece
2 pieces
1 piece