Télécharger Imprimer la page

HAMPTON BAY Legacy EST-340-10 Guide D'utilisation Et D'entretien page 9

Foyer panoramique

Publicité

Les langues disponibles

Les langues disponibles

Operation
Read All Instructions Before Use
Check that the heater outlet grill is not covered or obstructed in anyway, and make sure the power to the unit is switched on.
NOTE: When the heat function is used for the first time, a slight odor may be present. This is normal and should not occur again unless the heater
is not used for an extended period of time.
Control Panel
The control panel is located behind the door of the stove.
Power
Make sure the POWER switch is OFF. Plug the power cord into a 120 Volt 15 Amp grounded outlet (see Safety Information).
Flame Effect: Toggle POWER switch ON. The POWER indicator light will glow. Flame effect will be visible through the front glass.
Heat (Low): With the POWER switch ON, toggle the LOW (750W) switch ON. The LOW indicator light will glow. Warm air will blow.
Heat (High): With the POWER switch and LOW switch both ON, toggle the HIGH (1500W) switch ON. The HIGH indicator light will glow. Hot
air will blow.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn off. To reset: Unplug the power cord from the outlet. Wait 5 minutes. With the POWER switch
in the OFF position, plug the power cord back into the outlet.
All manuals and user guides at all-guides.com
9
Please contact 1-877-527-0313 for further assistance.
HAMPTONBAY.COM

Publicité

loading