Sauder Edge Water 408558 Instructions D'assemblage page 18

Step 13
Fasten four ANGLE BRACKETS (LL) to the BOTTOMS (F and G).
å
Use four BLACK 9/16" LARGE HEAD SCREW (GGG).
NOTE: Be sure the edges of the ANGLE BRACKETS are even
å
with the edge of the BOTTOMS.
Fasten the BOTTOM MOLDINGS (W) to the ANGLE BRACKETS.
å
Use four BLACK 9/16" LARGE HEAD SCREWS (GGG).
Fasten the METAL BRACKET (KK) to the TOP (E). Use a BLACK
å
9/16" LARGE HEAD SCREW (GGG).
Push the LARGE RUBBER SLEEVE (QQ) onto the METAL
å
BRACKET (KK). The RUBBER SLEEVE will be a tight fi t.
Flat edge
Page 18
LL
F
W
QQ
KK
BLACK 9/16" LARGE HEAD SCREW
Flat edge
W
E
408558
GGG
(9 used in this step)
LL
G
www.sauder.com/services