Kolpin 2623 Instructions D'installation page 3

Caution: over tightening any hardware could cause irreversible damage to the windshield.
Detail view
Detail view
To operate the tilt mechanism:
Simply loosen both 'T' knobs (without removing them) and push on the windshield from the inside of the cab until the desired position is
reached. Then tighten knobs. Note that there are 3 pre-determined positions on the slide arm; closed, half-opened and fully-extended.
• The tilt mechanism is designed for cooling the airflow in warm temperatures.
• Note that any open positions are designed for low-speed operation ONLY.
• At high speed riding or when transporting the vehicle, the windshield must be closed.
To remove the upper windshield:
Remove both 'T' knobs and follow reverse instructions 4, 3 & 2 of step #d).
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB or use
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and rinse. DO NOT
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of light transmission
- Fantastik1 - Joy2
2623 - Instructions POLARIS RANGER XP900 Full Tilt One Piece Ws - rev01
All manuals and user guides at all-guides.com
CLEANING:
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
and coating delamination.
Compatible Cleaning Agents

Aqueous Solution of Soaps and Detergents
- Neleco-Placer - Hexcel, F.O. 554
brushes or squeegees.
USE GASOLINE.
- Windex5 - Formula 4091 - Lysol3
IMPORTANT:
Torque specification
Max. 5 foot-pounds
Applicable to all
Clamp screws M6 x 20
- Pine-Sol4 - Mr. Clean2
WWW.KOLPIN.COM
- Top Job2
3