Publicité
Les langues disponibles
Les langues disponibles
c) Attach clamps (Item C) to the roll cage of your vehicle as per drawings.
Do not tighten at this stage; you will need to make adjustments
later on.
W-type clamp
Socket cap screw
M6 x 20
d) Attach upper windshield to the machine by following instructions below.
1.
Make sure that both upper clamps are at the same height.
2.
Hold the windshield horizontally and slide it down by ensuring that both upper pivot
cylinder adaptors are going through the upper pivot as per drawing #1.
3.
Pull gently on the windshield as per drawing #2 towards the front of the vehicle for the
upper pivot to slide to the end onto the upper pivot cylinder adaptor.
4.
Lower the windshield as per drawing #3 and the upper pivot will catch the second
upper pivot cylinder adaptor.
5.
Adjust the height of the upper clamp first by ensuring the overall leveling.
6.
Tighten all screws regarding the upper pivot.
7.
Adjust the height of the clamp to the lower pivot and slide arm and use 'T' knob to lock
in place. Drawing #4 shows the position you should have when windshield is closed.
8.
Tighten all remaining screws and nuts with specified torque indicated on next page.
2623 - Instructions POLARIS RANGER XP900 Full Tilt One Piece Ws - rev01
All manuals and user guides at all-guides.com
Locknut M6
Locknut M6
Top pivot
cylinder adaptor
Button head
screw
M6 x 45
Drawing #1
Drawing #2
Drawing #3
Drawing #4
WWW.KOLPIN.COM
2
Publicité
