Sears Kenmore ELITE C970 Serie Manuel D'utilisation Et D'entretien page 13

Setting Warmer Drawer Controls
To Set the Warmer Drawer & PROOF BREAD Controls:
The control and indicator lights for the Warmer Drawer Proof bread features are
located on the control panel. The temperatures are approximate, and are designated
by HI (high), MED (medium) and LO (low) and PROOFBREAD.
1. Touch the pad at the Warmer Drawer control position. The Warmer Drawer
indicator light will flash. Note: If no further pads are touched within 25 seconds
the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
(see Figure 2) or
Warmer Drawer indicator light located above the ON/OFF pad will turn ON steady.
3. Each touch of the
levels from HI (see Figure 2) to MED (see Figure 3) to LO (see Figure 4) and to
the PROOF BREAD feature (see Figure 5). If the Warmer Drawer is set at the LO
setting and the pad is touch again the Proof Bread feature and indicator light
will be set (see Figure 5 and bread dough preparation instructions on this page).
To return to standard Warmer Drawer setting touch
For best results, preheat the Warmer Drawer before adding the food or bread
dough. An empty drawer will preheat in approximately 15 minutes.
4. When the food is ready for removal, touch the
Drawer or Proof Bread feature OFF. The Warmer Drawer indicator light will turn
OFF.
Preparing Bread Dough for the Warmer Drawer
The Warmer Drawer has a Proof Bread feature that can be used to help
prepare bread dough. The recommended length of time to keep bread
dough in the Warmer Drawer is about 45-60 minutes. Be sure however
to follow the recipe's recommended times.
The unrisen bread dough should be placed in a large bowl since the
dough will nearly double in volume. Arrange the Warmer Drawer Rack
in the downward position (see Figure 6). Place the bowl on the rack in
the Warmer Drawer and follow the Warmer Drawer and Proof Bread
Control setting instructions at the top of this page.
Note: The Warmer Drawer is inoperable during the self-clean cycle.
All manuals and user guides at all-guides.com
once to turn ON the power level for HI
to turn ON the power level for LO (see Figure 4). The
or pads will decrease or increase through 6 power
(continued)
pad at least once. Note:
pad once to turn the Warmer
13
Figure 1
Figure 2 Figure 3
Figure 4
Figure 5
Figure 6