Publicité
Les langues disponibles
Les langues disponibles
H0
H0
Starting up
H1
H1
H2
H2
H3
H3
H4
H4
k St retc h
1 – ATTACHING THE FOOTREST
a) First attach the rotating shaft to the fixed axle. Ensure that the R-bolts are the correct way
round (Illustration 1).
b) Once the fixed axle is aligned and combined (Illustration 2), join the pieces together.
Illustration 1
c) Place the R-bolt through the holes on both sides to secure the footrest. (Illustration 3)
d) Assembly complete (Illustration 4)
Illustration 3
e) Connect the air tube and the power connection holder of the foot section to the counter-
part coming from the lower seat section.
NOTE
• To avoid injuries and damage to the product, the footrest should not be lifted from the
outside or pressed down. (Illustration 1)
• In order to avoid sitting in an uncomfortable position, make sure that the massage
mechanism has not stopped in an upright position in the seat cushion. (Illustration 2)
Illustration 1
32
Illustration 2
R-bolt
Illustration 4
Illustration 2
Starting up
2 – FITTING AND USING THE HEAD AND BACKREST CUSHION
Please connect the backrest cushion as shown in (Illustration 1) using the practical zipper on
the massage chair. Please fasten the pillow using the Velcro strips on the upper part of the
back cushion (Illustration 2). To clean the backrest cushion, you can easily separate it from
the chair by pulling the zipper. We would strongly advise that you do not use the massage
chair without the backrest cushion.
3 – FLOOR PROTECTION
In order to prevent excessive wear and tear of your floor covering due to the heavy weight
of the massage chair, we recommend placing carpet or similar underneath the chair.
NOTE
The massage chair should not be pushed over uneven or delicate floor surfaces, but should
be carried by at least 2 people. To do this, lift the chair using the handle on the back section
and the footrest. This way the footrest is completely folded up.
Zipper
Velcro strip
(1)
(2)
33
Publicité
