Projection Distance Worksheets - Epson ELPMB53 Guide D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Using the tables on pages 19 to 22, select the largest image size available for your
ceiling height.
Image height (h)
Image width (w)
4. Determine the desired distance from the floor to the bottom of the image area (f).
The recommended minimum distance is 30 inches (762 mm). Images appearing less
than 28 inches (711 mm) from the floor may be obstructed for some viewers.
5. Find the top of the projected image area by adding distances (f ) and (h).
6. Use the tables on pages 19 to 22 to determine the required distance from the top of the
image area to the bottom holes of the wall plate (c).
7. Use the tables on pages 19 to 22 to determine the required distance between the top
of the image area and the temporary wall plate hole (d).
8. Add:
Required distance from top of image area to bottom holes of wall plate (c)
Height of image area (h)
Distance from floor to bottom of image area (f )
Height of wall plate plus cover
If the total exceeds the ceiling height, you will need to reduce the image size or reduce
the distance from the floor to the bottom of the image area.
9. After confirming your image size, use tape or a pencil to mark the distance (c) from the
top of the image area on the board to the bottom holes of the wall plate.
10. Align the
line (horizontal) on the template sheet with the (c) mark, then align the
center line on the template sheet with the center of the image area. Follow the
instructions on page 23 to install the projector.

Projection distance worksheets

The tables on the following pages provide installation information for the native image size. The minimum
ceiling height is based on an image 30 inches (762 mm) from the floor; if the image is lower, the minimum
ceiling height is reduced by the corresponding measurement.
Use the worksheets, the illustrations, and the information in the tables on the following pages to determine
the projection distance and placement of the wall plate.
16
_____ (h)
_____ (w)
_____ (f )
_____
_____ (c)
_____ (d)
_____ (c)
_____ (h)
_____ (f )
+10
inches
_____ total

Publicité

Chapitres

Table des Matières
loading

Table des Matières