Installation Requirements; Tools And Parts; Location Requirements - Whirlpool KEMD378SBL00 Instructions D'installation

Masquer les pouces Voir aussi pour KEMD378SBL00:

Instructions d'installation (17 pages)

Table des Matières

Les langues disponibles

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Phillips screwdriver

Measuring tape

Hand or electric drill (for wall cabinet installations)

1" (25 mm) drill bit (for wall cabinet installations)

Level

Parts needed

UL listed or CSA approved conduit connector

UL listed wire connectors

Parts supplied

# 8-14 x 1" screws - single oven (2), double oven (4)

Bottom vent (supplied on some models)

Two # 8-18 x ³⁄₈" screws - bottom vent (supplied on some

models)

Check local codes. Check existing electrical supply. See

"Electrical Requirements."

It is recommended that all electrical connections be made by a

licensed, qualified electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used.

Given dimensions provide minimum clearance with oven.

Recessed installation area must provide complete enclosure

around the recessed portion of the oven.

Grounded electrical supply is required. See "Electrical

Requirements" section.

Electrical supply junction box should be located 3" (7.6 cm)

maximum below the support surface when the oven is

installed in a wall cabinet. A 1" (2.5 cm) minimum diameter

hole should have been drilled in the right rear or left rear

corner of the support surface to pass the appliance cable

through to the junction box.

Oven support surface must be solid, level and flush with

bottom of cabinet cutout. Floor must be able to support a

total weight (microwave and built-in oven) of 238 lbs (108 kg).