Audizio PADOVA Manuel D'instructions page 6

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging. If the device has been
exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your device. Leave the device switched off until it has reached room temperature.
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the
mains voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The
unit must also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. LCD display
2. Quick preset 1-5
Hold to save a station as preset
Press to quickly recall a preset
3. Power
On/standby
4. Menu/Info
Press to show channel information
Press and hold to enter the menu
5. Mode
Press to change modes
6. Infrared remote control receiver
7. Volume control & Tune/Select
Rotate to adjust the volume level
Press and hold to auto search stations
Press during BT- and USB playback to pause/play
When in menu, press to select input
8. Previous
Press to select the previous track in BT and USB modes
Press to open station list in DAB- and FM modes
9. Headphone jack
3.5mm jack for inserting headphones
10. Next
Press to skip to the next track in BT and USB modes
Press to open station list in DAB- and FM modes
11. Preset
Press to enter the preset list when in DAB- or FM mode
12. DC 7.5V power adapter input
13. USB slot
14. AUX input
3.5mm jack input for auxiliary play
• Remove the radio from the package box.
• Plug in the power adapter and press [Power].
Caution: Use only the adapter supplied with the radio. Connecting a power supply with a different rating can cause
permanent damage to the radio and may be hazardous.
If there is Digital Audio Broadcasting (DAB) in your area, the unit can pick up the DAB stations. The radio supports both DAB
and DAB+.
Place the radio close to the window and extend the antenna as far as it can go to get the best reception. Sometimes you may
need to adjust the direction of the antenna to improve reception.
Press [Mode] to select DAB mode.
Auto select: Press and hold [Tune/Select] to automatically scan for available DAB stations. After completing the automatic
search, press [Previous] or [Next] to enter the list with found stations. Rotate the [Tune/Select] knob to select another DAB
station. Press [Tune/Select] to confirm. Rotate [Tune/Select] to adjust the volume level when playback is active.
6