Philips FastCare GC7700 Serie Manuel D'utilisation page 8

ENGLISH
8
Safety auto-off mode (specific types only)
- To save energy, the steam generator switches off automatically when it has not been used for
15 minutes. The 'iron ready' light flashes.
- To reactivate the steam generator, set the on/off switch to 'off ' position and then to 'on' position.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause
The iron does not There is not enough water in
produce any the water tank.
steam.
You have not pressed the steam
trigger.
You have set the temperature
dial to 1.
The steam function has been
disabled until you have
performed the Calc-Clean
process.
You have not placed the water
tank in the appliance properly.
The Calc-Clean This is the Calc-Clean reminder.
light flashes and
the appliance
beeps.
The Calc-Clean You have not done or have not
light flashes and/or completed the Calc-Clean
the appliance process.
beeps.
The Calc-Clean You have not done or have not
light flashes and completed the Calc-Clean
the appliance process.
beeps every time
I press the steam
trigger. No steam
comes out of the
soleplate.
All manuals and user guides at all-guides.com
Solution
Fill the water tank beyond the MIN
indication. Press and hold the steam
trigger until steam comes out. It may take
up to 30 seconds until steam comes out.
Press and hold the steam trigger until
steam comes out.
Turn the temperature dial to 2
or higher.
Perform the Calc-Clean process to
restore the steam function
(see chapter 'IMPORTANT - Cleaning
and maintenance').
Slide the water tank into the appliance
until it locks into place ('click').
Perform the Calc-Clean process within
1 hour after the Calc-Clean reminder is
given.
Perform the Calc-Clean process to
enable the steam function again
(see chapter 'IMPORTANT - Cleaning
and maintenance').
Perform the Calc-Clean process to
enable the steam function again
(see chapter 'IMPORTANT - Cleaning
and maintenance').