Kohler Sterling SP1500D Serie Instructions D'installation page 6

Measure
here.
Measure distance
"D" above curves in
the corners.
Angled
Base
Warning:
are curved or angled, measure above the curve or
angle. Failure to do so can result in an improperly cut
bottom track and can void the warranty.
2. Measure and Cut the Bottom Track
IMPORTANT! Risk of product damage. If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure above the curve or
angle could result in the bottom track being cut too short.
Determine the pivot end of the bottom track. If you are not sure which end is the pivot end,
position the bottom track on the ledge with the front side of the track toward the outside of the
shower.
Measure from wall to wall at the flattest part of the shower ledge (Distance D).
Subtract 9/16" (1.4 cm) from dimension "D." The resulting dimension is the bottom track cut length.
IMPORTANT! Measure from the pivot side of the bottom track. Mark and cut the strike side.
Mark the strike side at the determined distance (see the previous section to determine the strike
side).
NOTE: For best results use a miter box and 32-teeth per inch hacksaw to make the cut.
Cut the bottom track at the mark. Do not cut the pivot end.
File the rough edges smooth where the bottom track was cut, taking care to avoid damaging
finished surfaces.
1034026-2-D
All manuals and user guides at all-guides.com
Measure
here.
Curved
Base
D
Measure carefully. If your walls
Important: Do not cut on the pivot side.
9/16"
(1.4 cm)
Pivot End
Front Side of
Bottom Track
For Left Pivots
9/16"
(1.4 cm)
6
For Right Pivots
Pivot End
D
Sterling