Oceanic OCEABV1300B Guide D'utilisation page 26

2. Connect the unit to a properly functioning outlet.
3. The red light indicator will then light up. It shows that the device is heating up. If the signals do not light up,
refer to the "self-help" section.
4. The heating time is about 20 seconds. When the unit is ready for operation, a blue signal will light up in the
tank and the unit will steam automatically.
5. When the tank is full, the unit can run continuously for about 20 minutes. When there is not enough water
in the tank, the red light indicator (10) will light on on to indicate that the tank must be refilled.
NOTE: If the unit turns off during or after the warm-up time, turn it on again. The unit will return to heating
mode.
WARNING ! Do not touch the broom head while cleaning. Risk of burns!
6. Adjust the steam intensity on button 8: turn clockwise to increase the pressure and counterclockwise to
decrease it.
NOTE: Wait about 3 seconds for the steam flow to adjust to the requested power.
WARNING ! Risk of burns!
The steam cleaner has a wide angle of action that allows you to clean under furniture and reach every corner.
Using the steam cleaner without the tube
Press the button on the lower part of the handle and remove
the main body A.
Install the accessory connector at the end of the main body.
Choose the appropriate accessory (refer to the accessories list)
then insert it into the adapter and screw it in until it is properly
fixed.
10
ENGLISH